8 Inch Submersible Turbine Pumps
Features
- 100% Franklin factory wet tested @ 3 points on curve
- Ductile iron discharge and suction bracket
- Ductile iron bowls bolt together for easy service
- Stainless steel upthrust bolt provides exceptional upthrust protection
- Bronze discharge bearing is grease packed for maximum bearing protection
- Fluted rubber bearings in all bowls
- Suction inlet located above bottom bearing prevents abrasives from entering the bearing
- Suction bracket design allows easy access to coupling
- Bronze bracket bearing is protected with stainless steel sand collar
- Stainless steel impellers with stainless steel taper lock secures impeller to shaft
- Stainless steel pump shaft for increased durability
- Shaft coupling is keyed to pump by set screws and is splined to fit motor shaft
- All models have 6” and 8” motor fit
- 4” and 6” discharge tapping BSPP for 8” Turbines
